12. A lathe mounted on wooden skids is to be slid down a pair of planks placed against the back of a truck.
(a) If the coefficient of friction is 0.28, what angle should the planks make with the ground in order for the lathe to slide down at constant velocity?
(b) When the planks are at this angle, will the lathe start to slide down of its own accord?

A) Figure attached below

B) The linear speed of the coin = 0.59 m/s

C) Linear speed as coin begins to slip = 0.83 m/s

D) The tangential speed will remain the same as seen in part C

Given data :

mass of coin = 0.0050 kg

Distance of coin from the center of disk = 0.14 m

Time to make a complete revolution = 1.5 s

A) Diagram showing the vectors on the figure is attached below

Linear speed of coin = 2 * π * ( 0.14 ) / 1.5

                                   = 0.59 m/s

given that: friction between coin and disk = 0.50

Friction becomes maximum when coin begins to slip

Maximum frictional force (Fmax) =  uV

where V = mg

Equating equations ( 1 ) and ( 2 ) to determine the linear speed ( v )

v² = u*r*g

∴ v = √(u*r*g ) = √( 0.5 * 0.14 * 9.8 )

                        = 0.83 m/s

D) If the experiment is repeated with a second coin glued to the top of the first coin the tangential speed will remain the same

Hence we can conclude that The linear speed of the coin = 0.59 m/s Linear speed as coin begins to slip = 0.83 m/s , The tangential speed will remain the same as seen in part C

Learn more about Linear speed : https://brainly.com/question/24713716

[tex]P=U.I => I=\frac{P}{U}=\frac{1500}{110}=\frac{150}{11}<A>\\I=\frac{U}{R}=> R=\frac{U}{I} = \frac{110}{\frac{150}{11} }=8.06< ohm>[/tex]

The answer is: A. 8.06 ohm

ok done. Thank to me :>

Basically your liquid will go over the line because you are adding more mass. the balloon will inflate because  of mass filling it.  Part 1  I noticed that there was a change from the original line.   part 2  Some mass is lost. The bubbles are the gas leaving. The balloon increases in size because of the mass. The cup got heavier when I added the vinegar.

Gas leaving caused the bubbles.

The principle of operation of a pressurized garden sprayer is as follows;

A pressurized garden sprayer is a chamber which is filled with a liquid which can be a lubricant, paint or chemical, then filled with compressed air to allow the liquid to be sprayed at high pressure.

As it is pumped by hand, the compressed air with which it is filled serves the primary purpose of allowing the liquid to be sprayed at high pressure - an important requirement for performance characteristics of the sprayer.

Flammable liquids must not be used with such equipment.

Read more on pressurized sprayers:

https://brainly.com/question/8842747

Answer:

Explanation:

from F=ma, 30=5a, a=6

cause there's no gravity therefore they appear weightless

Answer:

What can electrical energy be transformed into?

Electrical energy is transformed into many forms - mechanical/kinetic, sound, heat, light, and other forms of electromagnetic radiation - by everyday appliances.

Explanation:

Answer:

none of the other answers could be correct.

Explanation:

The sun nuclear energy transfers to radiant energy A fire Chemical energy transfers to thermal and radiant energy. wind turbine Kinetic motion energy transfers to electrical energy. Lightbulb Electrical energy transfers to radiant and thermal energy. Radio Electrical energy transfers to sound energy.

The distance of the child from the center of the ride is 0.28 m.

The given parameters;

The angular speed of the child is calculated as follows;

[tex]\omega = \frac{1 \ rev}{4.2 \ s} \times \frac{2 \pi \ rad}{1 \ rev} \\\\\omega = 1.5 \ rad/s[/tex]

The radius of the circle is calculated as follows;

[tex]a_c = \omega ^2 r\\\\r = \frac{a_c }{\omega ^2} \\\\r = \frac{0.8}{1.5^2} \\\\r = 0.28 \ m[/tex]

Thus, the distance of the child from the center of the ride is 0.28 m.

Learn more about angular speed here: https://brainly.com/question/6860269

Answer:

0.667; 4.965

Explanation:

Look at the picture I attached for the force analysis.

a) The coefficient=Friction/Normal Force. Because it's at constant speed, the force of friction + mgsin58.1° (because it's on an inclined plane and has split forces) is equal to the applied force (70.4N). Normal force is not equal to weight force though, because the box is on an inclined plane; it's equal to mgcos58.1°.

b) If it were to break, then the box no longer has an applied force, and the direction of friction has changed to up the inclined plane. F=m/a, so acceleration = mgsin58.1°- Friction/mass

Answer:

  1.5 cm

Explanation:

The ratio of areas is the square of the ratio of diameters, so cylinder A has (1/2)^2 = 1/4 the area of cylinder B.

The volume of the cylinder is jointly proportional to its area and its height. So, for a fixed volume, the height is inversely proportional to the area.

Cylinder B has 4 times the area of cylinder A, so any volume moved from cylinder A to B will require only 1/4 of the change in height that is required in cylinder A.

The red piston in cylinder B rises 1.5 cm.

The light can definitely change the mystery material. This can occur through a change in temperature or color (option C).

A material is affected by light mainly if the material absorbs the light. Based on the chart, we know this mystery material can absorb two types of light:

Moreover, this phenomenon can lead to two main changes:

Based on this, the material can change its color or temperature.

Note: This question is incomplete; here is the missing part:

A. Yes, but the mystery material can change in only one way, such as by getting warm, because all the light that a material absorbs will affect that material in the same way.

B. No. The mystery material can’t change because the light is not a physical thing. Light cannot change physical things like the mystery material.

C. Yes and the mystery material can change in one or two different ways, such as by getting warm and/or changing color, because different types of light can cause different changes to a material when they are absorbed.

D. There is no way to know whether the mystery material will change or not.

Learn more about sunlight in: https://brainly.com/question/1603783

Answer:

steel

Explanation:

the close molecules in solids allows sound to travel at a faster speed

Sound will move quicker through Steel than in water and air.

Sound: This can be defined as an audible form of energy, that is radiated outward from a source.

⇒ Generally,

Sound wave travels fastest in solid,  more than in liquid or gas. This is because the molecules of solid are more closely together.

⇒ From the question above,

Therefore, sound will move quicker through Steel than in water and air.

Hence: sound will move quicker through Steel than in water and air.

Learn more about sound here: https://brainly.com/question/1199084

The characteristics of parallel circuits allow to find the correct answer for the question about what happens when a light bulb is:  

   D) Bulb 2 will stay lit and the light source will be stronger.

Electrical circuits have two forms and connection:  

   • Serie. In this case there is only one path through which current can circulate the current.  

   • Parallel. There are several roads where the current can circulate.  

In a parallel circuit, the total current in the circuit is the sum of the current in each branch, the voltage in all branches remains constant.

Let's analyze the claims:  

A) False. The bulbs are independent, what happens to one does not affect the other.

B) False. Both bulbs were on, so the second bulb should not be affected.  

C) False. When burn a light bulb, there is more current in the other branch, The opposite happens.  

D) True. When burn a light bulb there is more current in the other branch and therefore the light bulb 2 can dissipate more power by shining a little brighter.

In conclusion, using the characteristics of parallel circuits we can find that the correct answer for the question about what happens when a light bulb burns out is:  

        D) Bulb 2 will stay lit and the light source will be stronger.

Learn more about parallel circuits here:  brainly.com/question/23088951

Answer:

2 * 10^4

Explanation:

(3 * 10^4)(4 * 10^4) / (6 * 10^4)

= (12 * 10^8)/(6 * 10^4)

= 2 * 10^4

Answer:

3 bands

Explanation:

Basically, the Parametric EQ divides the audio spectrum into three bands, allowing you to enhance (or suppress) the level in that range.

Answer:

a

Explanation:

bc i said so its right lol

Answer:

magnitude and a direction

Explanation:

Explanation:

Here, kinetic energy of the body, K.E=10 J

Height attained by the body, h=5 m

h=5m

When the body attains maximum height, its kinetic energy is converted into potential energy.

P.E=K.E

⟹mgh=10

⟹m= 10/gh

= m = 10/(10×5) =0.2 kg (taking the value g as 10m/s²)

Now, ½mv²=10

0.2×v²=20

v²=20/0.2

v²=100

v=√100

v=10m/s.

hope this helps you.

[tex]\huge \bf༆ Answer ༄[/tex]

Let's solve ~

As we know the total energy [P.E + K.E = C] of the system remains constant throughout the motion,

So, When a stone was thrown initially it didn't had any potential energy (P.E = 0) but had kinetic Energy of 10 joules.

So, total energy = P.E + K.E = 0 + 10 = 10 joules

As per the given information, equate it with the formula.

Now, As it approaches 5m height it comes to rest, Therefore velocity = 0. And since velocity = 0 then Kinetic Energy = 0

Now, let's find the Potential Energy at that point ~

And here, the Total energy = P.E + K.E = 10 Joules

So,

Therefore, mass of the object is 0.2 kg = 200 grams

Now, plug the value of mass (m) in the equation of kinetic Energy to find the initial velocity of the stone ~

Hence, velocity of the particle at the beginning was 10 m/s

Answer:

Rube Goldberg Machine is "a comically involved, complicated invention, laboriously contrived to preform a simple operation." 2. What are the 6 Simple Machines? A. The 6 Simple Machines are: wedge, screw, lever, wheel and axel, inclined plane and pulley.

The average velocity of the car for the whole journey is 69.57 km/h.

The given parameters:

The time spent by the before refueling is calculated as follows;

[tex]t = \frac{d}{v} \\\\t_1 = \frac{240}{75} \\\\t_1 = 3.2 \ hours[/tex]

The time spent by the car for the remaining journey;

[tex]t_3 = \frac{320 - 240}{100} \\\\t_3 = 0.8 \ hr[/tex]

The total time of the journey is calculated as follows;

[tex]t = t_1 + t_2 + t_3\\\\t = 3.2 \ hr \ + \ 0.6 \ hr \ + \ 0.8 \ hr\\\\t = 4.6 \ hours[/tex]

The average velocity of the car for the whole journey is calculated as follows;

[tex]v = \frac{total \ distance }{total \ time} \\\\v = \frac{320}{4.6} \\\\v = 69.57 \ km/h[/tex]

Learn more about average velocity here: https://brainly.com/question/6504879

Ek = 1/2 mv^2

= 1/2 × 5 × (25)^2

= 1562.5 J

Answer:

I believe it is Carbon Dioxide because after yeast breaks down the glucose (sugar) molecule, it forms/creates CO2 and Ethanol. (though it might be Ethanol that creates the bubbles) I am not quite sure if this is correct, but I hope it helps! :,)

Answer:

Hope it will help you a lot.

Answer:

Explanation:

The force acting on an object given it's mass and acceleration can be found by using the formula

force = mass × acceleration

From the question

force = 0.49 × 4.8 = 2.352

We have the final answer as

Hope this helps you

Answer:

2. 4.63 x 10 to the -11th power

Explanation:

m1 = 3.1, m2= 6.3, d = 5.3, G = 6.67 × 10^-11

m1 · m2 = 3.1 · 6.3 = 19.5

d² = 5.3² = 28.1

19.5/28.1 = 0.694

(6.67 · 10^-11) · 0.694 = 4.63 × 10^-11

Answer:

Natural phenomenon

Explanation:

Gravity, or gravitation, is a natural phenomenon by which all things with mass or energy—including planets, stars, galaxies, and even light—are attracted to one another.

Examples of this can be:

The force that holds the gases in the sun.

The force that causes a ball you throw in the air to come down again.

The force that causes a car to coast downhill even when you aren't stepping on the gas.

The force that causes a glass you drop to fall to the floor.

Answer:

the answer is 2.

Explanation:

Microwave Radiation????????????

Answer:

Higher frequencies of light have shorter wavelengths.