A 25.0 L tank of nitrogen gas is at 25 oC and 2.05 atm . If the temperature stays at 25 oC and the volume is decreased to 14.5 L , what is the new pressure?

Answer:

Explanation:

its supposed to be not supported not inclusive because you said mix

Answer:

Explanation:

The balanced chemical equation between

SrO + 2HCl → H2O + SrCl2

Answer:

location on the periodic table

Explanation:

Answer:

The answer is C density.

Answer:

0.375 mols

Explanation:

mol:mass

1 : 44

x :16.5

cross multiply and get the answer

endothermic

Explanation:

I believe it's an endothermic but I'm not all too sure

Answer:

Pottasium nitrate is highly exothermic!However the dissolution of sodium nitrate in water is endothermic. Heat is absorbed during process.

Reaction takes place is

2KClO3 --> 2KCl + 3O2

from above equation 2 moles of potassium chlorate is forming 3 moles of Oxygen gas.

now given 6.83 moles of oxygen and moles of potassium chlorate is missing,

consider x moles of potassium chlorate are needed to form 6.83 moles of oxygen

from above condition, .

3 》》》》2

x 》》》》6.83

3/x = 2/6.83

x = 3×6.83/2

x= 10.245

Answer- 10.245 moles of potassium chlorate are needed to produce 6.83 moles of oxygen gas.

Answer:

Radioactive tracers are widely used to diagnose industrial reactors, for instance by measuring the flow rate of liquids, gases and solids.

Explanation:

Radioactive tracers are widely used to diagnose industrial reactors, for instance by measuring the flow rate of liquids, gases and solids. A radioactive tracer is a chemical compound in which one or more atoms have been replaced by a radioisotope.

heres the link for more information

https://www.iaea.org/topics/radiotracers#:~:text=Radioactive%20tracers%20are%20widely%20used,been%20replaced%20by%20a%20radioisotope

.

Answer:

1.)C₃H₈O

2)OH

3.)1-propanol

1.) C4H8O

2.) C2H6O or CH3CH2OH

3.)Ethanol

Explanation:

Hope this help

Answer:

See explanation.

Explanation:

Hello there!

In this case, according to the described chemical reaction, we first write the corresponding equation to obtain:

[tex]Cu+2AgNO_3\rightarrow 2Ag+Cu(NO_3)_2[/tex]

Thus, we proceed as follows:

Part 1 of 3: here, since the molar mass of silver and copper (II) nitrate are 107.87 and 187.55 g/mol respectively, and the mole ratio of the former to the latter is 2:1, we can set up the following stoichiometric expression:

[tex]m_{Cu(NO_3)_2}=1.29gAg*\frac{1molAg}{107.87gAg}*\frac{1molCu(NO_3)_2}{2molAg}*\frac{187.55gCu(NO_3)_2}{1molCu(NO_3)_2} \\\\m_{Cu(NO_3)_2}=1.12gCu(NO_3)_2[/tex]

Part 2 of 3: here, the molar mass of copper is 63.55 g/mol and the mole ratio of silver to copper is 2:1, the mass of the former that was used to start the reaction was:

[tex]m_{Cu}=1.29gAg*\frac{1molAg}{107.87gAg}*\frac{1molCu}{2molAg}*\frac{63.55gCu)_2}{1molCu} \\\\m_{Cu}=0.380gCu[/tex]

Part 3 of 3: here, the molar mass of silver nitrate is 169.87 g/mol and their mole ratio 2:2, thus, the mass of initial silver nitrate is:

[tex]m_{AgNO_3}=1.29gAg*\frac{1molAg}{107.87gAg}*\frac{2molAgNO_3}{2molAg}*\frac{169.87gAgNO_3}{1molAgNO_3} \\\\m_{AgNO_3}=2.03gAgNO_3[/tex]

Best regards!

Answer:

oxygen ion O2-

Explanation:

because it has 8 protons and gave gained 2 electron so O2-.

Answer:

15.5 moles

Explanation:

Applying,

PV = nRT.................. Equation 1

Where P = pressure, V = Volume, n = number of mole, R = molar gas constant, T = Temperature.

Make n the subject of the equation

n = PV/RT............... Equation 2

From the question,

Given: P = 0.899 atm, V = 425 L, T = 24 °C = (273+24) K = 297 K.

Constant: R = 0.083 L.atm/K.mol

Substitute these values into equation 2

n = (0.899×425)/(297×0.083)

n = 15.5 moles

Answer:

The cation is written first in the name; the anion is written second in the name. Rule 2. When the formula unit contains two or more of the same polyatomic ion, that ion is written in parentheses with the subscript written outside the parentheses.

When writing the formula of a compound that contains polyatomic ion, the metal is written first followed by the central atom in the ion and then other atoms that surround the central atom.

A poly atomic ion refers to an ion that comprises of more than one atom. Such ions are common in chemistry. Examples of polyatomic ions include; PO4^3-, BH4^- etc.

When writing the formula of a compound that contains a polyatomic ion, the metal is written first then the central atom in the ion follows before other atoms that surround the central atom in the ion.

Learn more: https://brainly.com/question/6284546

When the average kinetic energy of its particles increases, the object's thermal energy increases. Therefore, the thermal energy of an object increases as its temperature increases.

In chemistry, we define the temperature of a substance as the average kinetic energy of all the atoms or molecules of that substance. Not all of the particles of a substance have the same kinetic energy. At any given time, the kinetic energy of the particles can be represented by a distribution.

In physics, temperature is defined as the average kinetic energy of the particles in an object. ... When particles move more quickly, temperature is higher and an object feels warmer. When particles move more slowly, temperature is lower and an object feels cooler.

乁(ᵔヮᵔ)ㄏ

Answer:

53676 J

Explanation:

m = 355 g

c = 2.4 J/gºC

ΔT = 63°C

q = mcΔT

  = (355)(2.4)(63)

  = 53676 J

The amount of heat is 53676J to raise the temperature of 355 g of ethanol.

Temperature is a measurement of the amount of energy of the atoms in a system or a physical quantity that expresses hot and cold.

Heat is energy that is transmitted through one body to some other due to a temperature differential. When two bodies of different temperatures come together, energy can be transferred (heat flows) from the hotter to the colder.

It can be determined by the formula:

q =mCΔT.

where, q is heat, m is mass , C is and T is temperature.

Calculation of heat is shown below:

It is given that, mass of ethanol = 355 g, c = [tex]2.4 J/g^{0}[/tex] C, ΔT. = [tex]63^{0} C[/tex]

Now, put the values of given data in heat formula:

q =mCΔT

= 355×2.4×63

=53676J.

Therefore, the amount of heat will be 53676J to raise the temperature of 355 g of ethanol

To know more about heat and temperature click here.

https://brainly.com/question/1429452.

#SPJ2

Answer:

Nuclear processes, including fusion, fission, and radioactive decays of unstable nuclei, involve changes in nuclear binding energies.

Explanation:

mark me brainliest please

Answer:

it will all fall unless these is air

Explanation:

Answer:

If you do it carefully enough, a small amount of water will pour out of the glass — that's supposed to happen. But try not to let any air bubbles get into the glass. Finally, slowly remove the hand holding the cardboard in place.

Answer:

a chemical reaction occured

Explanation:

bubbling and fizzing after adding a substance, most offten means a chemical reaction is happening

Answer:

Pistil

Explanation:

I believe it is the pistil, because the pistil is part of the female reproductive system of a flower. A stamen is for the male reproductive system.

Answer:

The answer to your question is B

Answer:

Iron is limiting reactant

Explanation:

Based on the reaction:

Fe + S → FeS

1 mole of iron reacts per mole of Sulfur

To solve this question we must convert the mass of each reactant to moles using molar masses of each reactant. As the reaction is 1:1, the reactant with the lower amount of moles is limiting reactant.

Moles Fe -Molar mass: 55.845g/mol-

4.68g * (1mol / 55.845g) = 0.0838 moles

Moles S -Molar mass: 32.065g/mol-

2.88g * (1mol / 32.065g) = 0.0898 moles

As the amount of moles of Fe < Moles S,

Iron is limiting reactant

When 4.68 g of iron reacts with 2.88 g of sulfur to produce FeS, iron is the limiting reagent.

If in a chemical reaction two reactants are present and one of them is present in less quantity as compared to other, is known as limiting reagent.

Given chemical reaction is:
Fe + S → FeS

From the stoichiometry of the reaction it is clear that equal moles of both reactant is required for the formation of product, so their mole ratio is 1:1.

Now we calculate the moles by using the formula:

n = W/M, where

W = given mass

M = molar mass

Moles of 4.68g of iron = 4.68g / 55.845g/mole = 0.0838 moles

Moles of 2.88 of sulfur = 2.88g / 32.065g/mole = 0.0898 moles

Moles of iron is less as compare to the sulfur, so it is the limiting reagent.

Hence, iron is the limiting reagent.

To know more about limiting reagent, visit the below link:
https://brainly.com/question/14222359

Answer:

Fermentation, chemical process by which molecules such as glucose are broken down anaerobically. More broadly, fermentation is the foaming that occurs during the manufacture of wine and beer, a process at least 10,000 years old. The frothing results from the evolution of carbon dioxide gas, though this was not recognized until the 17th century.

Explanation:

looked it up-

Answer:

like babies or milk and cheese?

Explanation:

Answer:

0.188mol

Explanation:

Using the formula;

mole = mass/molar mass

Molar mass of hypomanganous acid. (H3MnO4) = 1(3) + 55 + 16(4)

= 3 + 55 + 64

= 122g/mol

According to this question, there are 22.912g of H3MnO4

mole = 22.912g ÷ 122g/mol

mole = 0.188mol

Answer:

Explanation:

I can’t explain but this is the answer LOL

Answer:

Electrostatic repulsion, strong nuclear force

Explanation:

The nucleus consists of protons and neutrons. protons are positively charged while neutrons possess no charge.

Since protons are positively charged, they repel each other strongly (like charges repel). This strong repulsion of like charges makes the nucleus somewhat unstable leading to spontaneous fission of heavy nuclei.

However, an opposing force called nuclear attractive force tends to hold the nucleons together. This attraction occurs when two nucleons are bonded by a particle called a π meson.

Hence, the two forces that act in the nucleus to create a  'nuclear tug-of-war' are electrostatic repulsion and a strong nuclear force.

Answer:

14.6

Explanation:

I just took the test

The amount of heat to raise the temperature is 14.7J.

The specific heat capacity of a substance is the quantity of heat needed to raise the temperature of a unit quantity of the substance by one degree. Calling the amount of heat added Q, which will cause a change in temperature ∆T to a weight of substance W, at a specific heat of material Cp, then Q = w x Cp x ∆T

By applying the formula, we get

Q = w x Cp x ∆T

Q = 300 * 2.46 * 20/1000

Q = 14.760J

Heat is energy that is transferred from one body to another as the result of a difference in temperature.

Learn more about the heat here: brainly.com/question/13439286

#SPJ2

Answer:

The titration process has quite a few real-world uses, including key roles in the food industry and medical community. The titration process is essentially an analytical technique, as it is used to determine a chemical or physical property of a chemical substance, element, or mixture (such as food). Specifically in the food industry, it is used to allow food manufactuers to determine the quantity of a reactant in a sample. To provide an example, it can be used to find the specific amount of stuff that is usually labeled on the nutrition label, such as sugar, salt, protein, calcium, vitamin C, etc. As for the medical world, pharamcists typically use this process to get the proper mix when compounding medicines. It is used to get the necessary proportions in intravenous drips.

Answer:

two hydrogen can bonded with oxygen to form H2O

Answer:

1.95 M

Explanation:

Molarity is a measure of the molar concentration of a substance (solution). In relation to the volume, it is calculated using the formula as follows;

C1V1 = C2V2

Where;

C1 = initial concentration (M)

C2 = final concentration (M)

V1 = initial volume (L)

V2 = final volume (L)

According to the provided information in this question;

C1 = 14.38 M

C2 = ?

V1 = 1.28 L

V2 = 9.45 L

Using C1V1 = C2V2

14.38 × 1.28 = C2 × 9.45

18.4064 = 9.45 C2

C2 = 18.4064 ÷ 9.45

C2= 1.95 M

Answer:

its b alkyne

Explanation:

brinliest po plsss

Answer:

Alkyne so its b