Answer:
this one is hard
Explanation:
but it's iron because the sodium so yea there u go.
Which of the following are used to administer liquid medications orally? O a) Syringes b) Vials c) Suppositories d) Droppers e) Teaspoons
Answer:
D
Explanation:
A baker was baking a cake which has burnt due to over heating. What kind of change is this ?
reversible
irreversible
burnt
heating
2CH3CHO+O2=> 2CH3COOH
Answer:
2CH3CHO + O2 → 2CH3COOH
An unknown solution contains several chemical substances. By following a series of steps in a procedure, each of these substances can be isolated. Which of the following methods would be most appropriate for showing the steps needed to separate the substances?
A. Draw a diagram of apparatus used.
B. Create a flowchart of the various steps.
C. Build a model of the various atomic structures.
D. Construct a graph showing the times needed for each step.
Answer:
Create a flowchart of the various steps.
Explanation:
Answer:
A.
Explanation:
have a nice day^^ good morning
What is the percentage of nitrogen in ammonium chloride (NH4Cl)?
Answer:
25%
Explanation:
Ammonium Chloride NH4CI Fertilizer-grade NH4Cl usually contains 25% N. About two-thirds of the world capacity for manufacture of this material is located in Japan, with the remaining one-third situated in India and China.
i. Three different representations of glucose are
given below. Identify each type
of model.
Answer:
Ball and stick model is 3D and has the atoms depicted as different Coloured balls Conected to each other by "sticks"
fischer projection has the atoms on the side coming out of the plane, the atoms at the ends going behind (going away from you)
bond line notation Is the most common it does not show the C or H bonds but instead carbons are represented by the bends
The three structures of glucose represent three different models, they are ball and stick model, Fischer projection and bond line notation, respectively.
Glucose is a type of simple sugar (carbohydrate) that does not further hydrolyze to give monosaccharides.
Ball and stick model: The atoms are portrayed as different colored balls connected to each other by "sticks." Fischer projection: The atoms on the sides of the plane are coming out of the plane, while the atoms at the ends are moving behind.Bond line notation: It is the most frequent representation method used; it lacks C and H bonds but instead depicts carbons through bends.Therefore, the three glucose structures reflect three distinct models: the ball and stick model, the Fischer projection, and the bond line notation, respectively.
Learn more about Glucose here:
https://brainly.com/question/30548064
#SPJ5
What is the molarity of aqueous lithium bromide if 25.0 mL of LiBr reacts with 10.0 mL of 0.250 M Pb(NO 3) 2
The molarity of aqueous lithium bromide, LiBr solution is 0.2 M
We'll begin by calculating the number of mole of Pb(NO₃)₂ in the solution.
Volume = 10 mL = 10 / 1000 = 0.01 L Molarity of Pb(NO₃)₂ = 0.250 MMole of Pb(NO₃)₂ =?Mole = Molarity x Volume
Mole of Pb(NO₃)₂ = 0.25 × 0.01
Mole of Pb(NO₃)₂ = 0.0025 mole
Next, we shall determine the mole of LiBr required to react with 0.0025 mole of Pb(NO₃)₂
Pb(NO₃)₂ + 2LiBr —> PbBr₂ + 2LiNO₃
From the balanced equation above,
1 mole of Pb(NO₃)₂ reacted with 2 mole of LiBr.
Therefore,
0.0025 mole of Pb(NO₃)₂ will react with = 2 × 0.0025 = 0.005 mole of LiBr
Finally, we shall determine the molarity of the LiBr solution
Mole = 0.005 mole Volume = 25 mL = 25 / 1000 = 0.025 L Molarity of LiBr =?Molarity = mole / Volume
Molarity of LiBr = 0.005 / 0.025
Molarity of LiBr = 0.2 M
Learn more about molarity: https://brainly.com/question/10103895
What is a system?
A. A piece of scientific equipment
B. A liquid in which reactions take place
C. A technique for recording data
D. An isolated piece of the world
Answer:
C
Explanation:
A system is often defined as a procedure (a way to outline steps). C makes the most sense here.
Which hypothesis is most supported by astronomers?
A- The universe is currently expanding and will continue to expand.
B- Stars could burn out, causing the universe to become dark and cold.
C- Gravity could pull galaxies back together, causing a reverse of the big bang.
D- Dark energy will pull the universe together to form a massive black hole.
HURRY!!
Answer:
option A is the most supported hypothesis by astronomers
Hydrogen gas reacts with oxygen gas to form water. What is the excess reactant in this recation(Refer to the picture below to answer).
A. Water
B. Hydrogen gas
C. Oxygen gas
D. Water and oxygen gas
Answer: C. Oxygen Gas
Explanation: When Hydrogen Gas and Oxygen Gas combine together it forms water correct. When you have an excess amount of another it stays neutral because it has no other molecule to react with.
How/ why does weather "happen," on Earth?
aused by the weight of the huge numbers of air molecules that make up the atmosphere. ... When air pressure is low, air flows together and then upward where it converges, rising, cooling, and forming clouds.
Answer:
Explanation:
The weather events happening in an area are controlled by changes in air pressure. Air pressure is caused by the weight of the huge numbers of air molecules that make up the atmosphere. ... When air pressure is low, air flows together and then upward where it converges, rising, cooling, and forming clouds.
A Carnot engine takes 2000 j of heat from a reservoir at 500 k, does some work and discards some heat to a reservoir at 350k . how much work does it do, how much heat is discarded, and what is it's efficiency?
Answer:
Explanation:
The Carnot engine is a theoretical or conceptual heat engine that has a higher efficiency than any practical or theoretical heat engine working between the same temperature range. The theoretical efficiency of a Carnot engine is considered as the highest efficiency and no practical heat engines can operate at that efficiency. A Carnot engine draws heat energy, performs useful work and the leftover energy is released from the working substance. According to the second law of thermodynamics, there must be a temperature gradient between the heat energy drawing point and release point of the heat engine.
A Air at a temperature of 134°C and atmospheric pressure flows with a velocity of 7 m/s over
a smooth 5 m long and 1 m wide cast iron plate. Under steady-state conditions, the air-side
surface temperature of the plates is at 120°C. Under the described conditions, determine the
overall heat transfer rate through the plate.
B-If the flat plate in (A) is replaced with a cylinder with the same surface area (heat transfer
area) and the cylinder's length is the same as the width of the plate (1.0 m), what would be the
heat transfer rate for cross air flow over the outside surface of the cylinder?
C. If the flat plate in (A) is replaced with a sphere with the same surface area (heat transfer area),
what would be the heat transfer rate for cross air flow over the outside surface of the sphere?
D- Based on your results, discuss which surface configuration is more effective for heat
what is the name of the compound CaCo3
Anyone mind answering this
How many liters of 0.200 M sodium hydroxide do you need to titrate 0.300 L of a 0.100 M diprotic acid to the equivalence point?
The volume of the sodium hydroxide solution needed for the reaction is 0.3 L
We'll begin by writing the balanced equation for the reaction.
H₂X + 2NaOH → 2H₂O + Na₂X
From the balanced equation above, the following data were obtained:
The mole ratio of the acid, H₂X (nA) = 1The mole ratio of base, NaOH (nB) = 2From the question given above, the following data were obtained:
Molarity of base, NaOH (Mb) = 0.2 M. Volume of acid, H₂X (Va) = 0.3 L. Molarity of acid, H₂X (Ma) = 0.1 M. Volume of base, NaOH (Vb) =?MaVa / MbVb = nA / nB
(0.1 × 0.3) / (0.2 × Vb) = 1/2
0.03 / (0.2 × Vb) = 1/2
Cross multiply
0.03 × 2 = 0.2 × Vb
0.06 = 0.2 × Vb
Divide both side by 0.2
Vb = 0.06 / 0.2
Vb = 0.3 LTherefore, the volume of NaOH needed for the reaction is 0.3 L
Learn more on titration: https://brainly.com/question/23298305
Answer all questions please and be quick, it’s very URGENT
hi uhm
Explanation:
it's dark and lighting
If you only wanted to increase the particle motion of a gas without increasing any of its other properties, which would the most correct situation?
a. Keep the gas at a constant pressure and keep the temperature constant, but increase the volume of the gas
b. Keep the gas in a fixed container at constant pressure and increase the temperature
c. Keep the gas in a fixed container at constant pressure and decrease the temperature
d. Keep the gas at a constant volume and keep the temperature constant, but decrease the pressure of the gas
Answer:
c
Explanation:
a. Anna's chemistry class is going to be experimenting with AgNO3 today, which
can stain hands and clothes. Anna is concerned about her jewelry, so as she
gets ready for school, she removes her gold (Au) ring andreplaces it with a
cheaper nickel (Ni) ring. Is this a good idea? Explain your answer. (3 points)
Answer:
No. While gold would not react with a silver nitrate solution, nickel would.
Explanation:
Refer to the metal reactivity series.
Reactivity: [tex]\text{Gold} < \text{Silver} < \text{Nickel}[/tex].
Gold is positioned after silver in the reactivity series, meaning that gold is typically less reactive than silver. Thus, gold would not react with a solution of silver ions to produce silver metal.
However, since nickel is positioned before silver in the reactivity series, it is expected that nickel would react with silver ions in this solution to produce silver metal.
Thus, if the silver nitrate solution comes into contact with the two rings, the nickel ring would likely react with the solution, the gold ring would not.
what is the continent bellow the world?
Answer:
antarcita
Explanation:
Answer:
What is the continent bellow the world?
Antarctica is the continent below the Earth.Elements with ________ atomic mass are best possible candidates for a fusion reaction. very low moderate to heavy moderate very heavy
very low
Explanation:
Nuclear fusion is a nuclear reaction wherein small nuclei are combined to form heavier nuclei. This process constantly occurs in the sun, which is mainly composed of hydrogen and helium atoms.
For an imaginary closed economy, T = $5,000; S = $11,000; C = $48,000; and the government is running a budget surplus of $1,000. Then
Based on the information given, the private savings will be $10000 and the gross domestic product is $63000.
From the information given, he following can be gotten:
T = $5,000S = $11,000C = $48,000Budget surplus = $1000Since, S = Y - C - G
11000 = Y - 48000 - G
Y - G = 48000 + 11000
Y - G = 59000
Budget surplus = T - G = 1000
5000 - G = 1000
G = 5000 - 1000 = 4000
The GDP will be:
Y - G = 59000
Y - 4000 = 59000
Y = 59000 + 4000 = 63000
Private savings = Y - T - C
Private savings = 63000 - 5000 - 48000
Private savings = 10000
Learn more about GDP on:
https://brainly.com/question/1383956
Which of the following is not a place where hydrogen can be found on Earth?
A) Natural gas well
B)
Water
Mine
Atmosphere
Answer:
Atmosphere
Explanation:
Natural gas is mainly hydrocarbons like C3H8 and that has hydrogens, water is H2O and had hydrogens, mines have it in the minerals.
In a Lewis Diagram for fluorine, are the two electrons given to the other fluorine atom, taken by the other fluorine atom, or shared between the fluorine atoms?
What physical property does salt have when it is dissolved in water?
And
What type of mixture is salt water?
I want a pharmacist technician to help me with a question please
Answer the following question attached!!
Answer:
I think It is Covalent. Not 100% sure but like 90% sure.
3 useful applications of alkaline earth metals
Answer:
1 used in paint , toothpaste
2 used in fireworks and magnets
3 used to manufacture alloys
Below the time line, list the layers from oldest to youngest
Answer:
F,E,D,C, B, A, G, H, I
Explanation:
I think. It goes bottom to top. the fault probably cause g to happen and maybe h but mattering on what caused what I am not positive
activation energy in reaction is used to:
A- Overcome repulsion force between colliding molecules
B- Breaking bonds
C- Merge Valence electrons
D- All of them
Answer:
D — All of them
Explanation:
The activation energy in a reaction is the minimum amount of energy required for a chemical reaction to take place. Since all the options are processes in a chemical reaction, D should be the answer.