State charles's law. If a balloon occupies 885 cm3 volume at 20°C and 794 cm3 at - 10°C , prove that this is according to charles's law.

Answer:

is this physics

pls check your questions and try again

This question is providing the masses of carbon dioxide and oxygen gases at 10.0 atm as 66 g and 16 g respectively, and is asking for the partial pressure of the former which turns out to be 7.50 atm after doing the math.

Thus, we can start solving this problem with the Dalton's law approach, in order to make a relationship for the total pressure, partial pressure and mole fraction, which means we must first determine the mole fraction of carbon dioxide gas in the mixture as shown below:

[tex]x_{CO_2}=\frac{n_{CO_2}}{n_{CO_2}+n_{O_2}}[/tex]

Next, we calculate the moles of both gases by dividing the grams over the molar masses:

[tex]n_{CO_2}=\frac{66g}{44.01g/mol} =1.50mol\\\\n_{O_2}=\frac{16g}{32g/mol} =0.5mol[/tex]

Then, the mole fraction of carbon dioxide as the required one by plugging in the previously calculated moles:

[tex]x_{CO_2}=\frac{1.5}{1.5+0.5}=0.75[/tex]

Finally, we use the definition of the Dalton's law to calculate the partial pressure of carbon dioxide gas in the binary mixture:

[tex]P_{CO_2}=x_{CO_2}P\\\\P_{CO_2}=0.75*10.0atm\\\\P_{CO_2}=7.50 atm[/tex]

Learn more:

(Dalton's law) https://brainly.com/question/14119417

Answer:

D.

Explanation:

A concentrated solution is one that has a lot of solute (the substance being dissolved) in the solvent (the substance doing the dissolving). When a solution is concentrated, it means it has a high ratio of solute to solvent, so the answer is D.

Hope this helps.

The equilibrium constant of the reaction is 0.042.

The reaction equation is given as;

PCl5(g) ⇄ PCl3(g) + Cl2 (g)

Recall that this equation shows the decomposition of phosphorus pentachloride.

We have the following equilibrium concentrations;

[PCI5]= 0.0095 M

[PCI3] = 0.020

[CI2] = 0.020 M

The equilibrium constant, K is obtained from;

K =  [PCI3]  [CI2]/[PCI5]

K = [0.020]^2/[0.0095]

K = 0.042

Learn more: https://brainly.com/question/17960050

Answer:

    2H2    +   1 O2   ------>    2H2O

m = 12.7g                              m = ?

Get the number of moles for Hydrogen gas (H2) by dividing the mass by the molar mass (1.01g/mol as listed in the periodic table for its atomic mass)

12.7/1.01 = 12.57 mol of H2

Now use the mole to mole ratio of Hydrogen gas (H2) and water (H2O).

From the balanced equation, we can see that 2 mol of H2 gives us 2 mol of H2O. Since both of the ratios are equal (2:2), the moles we have for hydrogen gas is the same as the moles we get for water.

12.57 mol of H2O

Now that we have the amount of mol for H2O produced in this reaction, we can convert it to grams by multiplying the moles by the molar mass.

Molar mass of H2O = (1.01 x 2) + (16) = 18.02g/mol

12.57 x 18.02 = 226.5g (rounded)

Therefore 226.5g of water will be produced in this reaction

According to law of conservation of mass and stoichiometry, 114.3 g of water are produced if 12.7 grams of hydrogen reacted with an unknown amount of oxygen.

According to law of conservation of mass, it is evident that mass is neither created nor destroyed rather it is restored at the end of a chemical reaction .

Law of conservation of mass and energy are related as mass and energy are directly proportional which is indicated by the equation E=mc².Concept of conservation of mass is widely used in field of chemistry, fluid dynamics.

2 H₂ + O₂[tex]\rightarrow[/tex] 2 H₂O,according to this equation,4 g hydrogen reacts with 32 g oxygen to give 36 g water, thus 12.7 g of hydrogen will produce 12.7×36/4=114.3 g water and hence for this amount of water to be formed  12.7 g of hydrogen reacts with 101.6 g of oxygen which is obtained as 114.3-12.7=101.6 g

Thus, 114.3 g of water is produced.

Learn more about law of conservation of mass,here:

https://brainly.com/question/28711001

#SPJ2

Answer:

4) 1.5 mol

Explanation:

Well, the equation is already balanced and the mole to mole ratio of reactants and products are all 1. So if the limiting reactant is HCl and you have 1.5 mol, you do the mole to mole ratio with NaCl and since it is 1 to 1, there'd be 1.5 mol of NaCl.

Answer: Metals conduct heat and reduce the kinetic energy within the components that need to remain cool.

Explanation:

Answer:

Explanation:

Endo and Exo thermic are defined by what changes take place in the environment of the reaction.

If the temperature goes up, the reaction is giving up heat. It is Exothermic.

If the temperature goes down, the reaction requires heat. It is Endothermic.

In this case, the temperature went down. The reaction is Endothermic.

Answer:

Magnesium is Mg.

Phosphorus is P.

Answer:

I think the answer is A physical property is a characteristic of a substance that can be observed or measured without changing the identity of the substance. Physical properties include color, density, hardness, and melting and boiling points. A chemical property describes the ability of a substance to undergo a specific chemical change.

Explanation:

I hope this helps.

Answer:

Physical change is the same substance, while a chemical change is a new substance.

Answer:

By their properties ;)

Explanation:

[tex]\Large \boxed{\sf by \ their \ properties}[/tex]

Every element has a set of particular characteristics. Each has a unique atomic and mass number because they contain a different ratio of protons and neutrons. The number of protons in an element mirrors the element's atomic number. The mass number equals the sum of the element's protons and neutrons.

According to increasing atomic numbers, chemical elements get organized. Periods and groups are the names of the horizontal rows and vertical columns, respectively. The chemical characteristics of elements within the same group are comparable due to their similar valency and number of outer electrons.

Answer:

I = W/V

Explanation:

Comes from the Equation P=I*V where P is Power measured in Watts, I is Current measured in Amps and V is Voltage measured in Volts.

The mass of water needed to absorb 456 J is 1.44 g

We'll begin by calculating the change in the temperature of the water.

Initial temperature of water (T₁) = 22.7 °C

Final temperature (T₂) = 98.3 °C

ΔT = T₂ – T₁

ΔT = 98.3 – 22.7

Heat absorbed (Q) = 456 J

Change in temperature (ΔT) = 75.6 °C

Specific heat capacity of water (C) = 4.184 J/gºC

Q = MCΔT

456 = M × 4.184 × 75.6

456 = M × 316.3104

Divide both side by 316.3104

M = 456 / 316.3104

Therefore, the mass of the water is 1.44 g

Learn more: https://brainly.com/question/15563205

Answer:

163.94

Explanation:

Na = 22.99 (3)

P = 30.97

O = 16.00 (4)

22.99(3) + 30.97 +16.00(4) = 163.94

Hope that helps

Answer:

3 elements are present in thr compound

Answer:

E\charged battery to provide electronic difference

Answer:

FIGURE 5.9 The arrow shows a second way of remembering the order in which sublevels fill. Table 5.2 shows the electron configurations of the elements with atomic numbers 1 through 18.

Element Atomic number Electron configuration

sulfur 16 1s22s22p63s23p4

chlorine 17 1s22s22p63s23p5

argon 18 1s22s22p63s23p6

Explanation:

Brainlilest me

Answer:

2:true

3: true

4:false

5: true

Explanation:

Answer:

A

Explanation:

The empirical formula won't always represent a molecule if the molecular formula is not the smallest ratio between elements.

Answer:

Both

Explanation:

if you pull a mountain a part that would be great consequences and if a volcano breaks there will be fire .

Answer:

Part 1: Condensation is when - a

Condensation happens when- water vapour suddenly freezes

Part 2: Water, condenses, vapour, cold, droplets, Condensation

Answer: photosphere.

Explanation:

The part of the Sun commonly called its surface is the photosphere. The word photosphere means "light sphere" – which is apt because this is the layer that emits the most visible light. It’s what we see from Earth with our eyes.

Answer:

The ideal gas law specifies the mechanical behavior of ideal gases. It is capable of calculating the volume of gases produced or consumed.

In chemical equations, these equations are widely used to convert between volumes and molar quantities.

Use ideal gas law

Therefore

is the same for both So, = same for both.

When n increases, T decreases, so, n is 1 for and 0.5 for , implying that is hotter.

The temperatures of the gases will not be equal.

[tex]PV=nRT[/tex]

∵V is the same for both

∴T= same for both.

When n increases, T decreases, so, n is 1 for hydrogen gas and 0.5 for  oxygen gas ,implying that oxygen gas will have more temperature than hydrogen gas since its number of moles are lower than hydrogen gas.

Learn more:

brainly.com/question/1063475

Answer: In a pure metal, there are atoms that are surrounded by free moving valence electrons in which they move from one part of metal to another part . There for we can conclude that pure metals are held together by things called metallic bonds and due to attraction between the mobile valence electrons and the positively charged metal ions.

Explanation:

The ability to be drawn into thin sheet is called malleability. The ability to be drawn into thin wires is called ductility. Therefore, the metallic bonds is between metals and metals.

Metallic bonding is a type of chemical bonding that rises from the electrostatic attractive force between conduction electrons and positively charged metal ions.

Covalent bonds are not strong bond. They can not have malleability and ductility. Ionic bonds are very strong bond. These are too not malleable or ductile. Lewis structure is used to show valence electron of every element in a molecule so, it has nothing to do with malleability and ductility. Due to metallic bonding, there is high melting and boiling point.

Therefore, the metallic bonds is between metals and metals.

To know more about metallic bonding, here:

https://brainly.com/question/11752090

#SPJ2

Answer:

Definition and Mathematics of Work

Calculating the Amount of Work Done by Forces

Potential Energy

Kinetic Energy

Mechanical Energy

Answer:

[(15g NaCl/(70+15)]*100 = % NaCl

{(70g H2O/(70+15)]*100 = % H2O

Explanation:

A solution is prepared by dissolving 15.0 g of table salt in 70.0g of water. (a) The mass percent of solute is 17.64 % and (b) The mass percent of solvent is 82.35 %.

Mass percentage = [tex]\frac{\text{Mass of solute}}{\text{Mass of solute + Mass of solvent}}[/tex]  × 100

Mass percentage = [tex]\frac{\text{Mass of solvent}}{\text{Mass of solute + Mass of solvent}}[/tex] × 100

Here,

Mass of solute (table salt) = 15.0 g

Mass of solvent (water) = 70.0 g

(a) The mass percent of solute

Put the value in above formula we get

Mass percentage = [tex]\frac{\text{Mass of solute}}{\text{Mass of solute + Mass of solvent}}[/tex] × 100

                             = [tex]\frac{15}{15 + 70}[/tex] × 100

                             = [tex]\frac{15}{85}[/tex]  × 100

                             = 17.64 %

(b) The mass percent of solvent

Mass percentage = [tex]\frac{\text{Mass of solvent}}{\text{Mass of solute + Mass of solvent}}[/tex] × 100

                             = [tex]\frac{70}{15 + 70} \times 100[/tex]

                             = [tex]\frac{70}{85} \times 100[/tex]

                             = 82.35 %

Thus, we can say that (a) The mass percent of solute is 17.64 % and (b)  The mass percent of solvent is 82.35 %.

Learn more about the Mass Percentage here: https://brainly.com/question/26150306

#SPJ2