What is the freezing point on this graph?

Answer:

please use shell notation

Answer:

1- The components in a series circuit are arranged in a single path from one end of supply to another end. However, the multiple components in a parallel circuit are arranged in multiple paths where the two end terminals of the battery.

2- In the series circuit, different voltage exists across each component in the circuit. Whereas in the parallel circuit, the same voltage exists across the multiple components in the circuit.

3- The equivalent resistance in case of a series circuit is always more than the highest value of resistance in the series connection. While the equivalent resistance in the parallel circuit is always less than any of the individual resistances in parallel combination.

4- A fault in one of the components of the series circuit causes hindrance in the operation of a complete circuit. As against fault in a single component in a parallel network do not hinder the functioning of another part of the circuit.

The detection of a fault in case of a series circuit is difficult, but it is quite easy in parallel circuits.

Answer:

nucleus

Alpha particles are subatomic fragments consisting of two neutrons and two protons. Alpha radiation occurs when the nucleus of an atom becomes unstable (the ratio of neutrons to protons is too low) and alpha particles are emitted to restore balance.

Explanation:

Answer:

No, it looks like there is no gas forming no foaming or burning so it is not

Explanation:

Answer:

A Mass number

Explanation:

did it on edge2020

Answer:

= 16 cells

Explanation:

Mitosis is the stage of cell division in nonsexual cells of eukaryotic organisms (that is, cells that have a nucleus). It takes place in several phases, begins after DNA duplication and ends with the separation of the two daughter cells.

It is a fundamental mechanism that occurs for the first time in the hours following fertilization.

After duplication of the genetic material, during interphase, it condenses and groups to form chromosomes with two genetically identical chromatids: this is the prophase. The nuclear membrane then dislocates, and the centromeres of the chromosomes (the area where the two chromatids of the same chromosome overlap) bind to the microtubules via the kinetochores. Gradually, all the chromosomes are sequestered at the equator of the cell: this is the metaphase.

Then, during anaphase, the chromosomes will split into two chromatids, each of which is pulled towards a pole of the cell. Thus, at each top of the cell, there is a copy of each chromosome. During telophase, the nuclear envelope will begin to reform around the set of chromosomes as the DNA gradually decondensed. The plasma membrane invaginates equatorially under the action of a ring of myosin and actin. Increasingly narrow, the bridge between the cells eventually breaks, and two cells are formed as a result of cytodieresis. Each of them can resume their growth.

Now; having understood what Mitosis is all about.

When a single cell undergoes mitosis every 5 minutes; we have the formation of two daughter cells.

Then in 20 minutes; we will have:

= [tex]2^{20/5}[/tex]

= [tex]2^4[/tex]

= 16 cells

Answer:

The number of atoms in 3.47 gram nugget of gold is approximately 1.0606 × 10²² atoms

Explanation:

The given mass of gold = 3.47 grams

The molar mass of gold = 196.96657 g/mol

The number of moles of gold in 3.47 grams of gold = 3.47 grams/(196.96657 g/mol)

The number of moles of gold in 3.47 gram nugget of gold = 0.01762 moles

The number of atoms in one mole of gold = 6.02 × 10²³ atoms

The number of atoms in 0.01762 moles of gold = 6.02 × 10²³ atoms/mole × 0.01762 moles

The number of atoms in 0.01762 moles of gold ≈ 1.0606 × 10²² atoms

∴ The number of atoms in 3.47 gram nugget of gold ≈ 1.0606 × 10²² atoms.

Answer: 2 kg

Explanation:

Answer:

The phases of the species should be indicated by the spacing and distribution of the particles in the diagram

Explanation:

Evaporation would be a phase change from liquid to gas where intermolecular forces are broken CCl4 (l) -> CCl4 (g)

Diagram is attached below

We have that  from the diagram that when CCl4(l)  is placed in a previously evacuated container at 30°C , and some of the CCl4(l) evaporates that the molecules of CCl4(g)  becomes loosely held and apart from while in its closely held in its liquid state.

From the question we are told

CCl4(l) is placed in a previously evacuated container at 30°C , and some of the CCl4(l) evaporates. In the box below, draw a particulate diagram to show the species in the container after some of the CCl4(l) has evaporated. The phases of the species should be indicated by the spacing and distribution of the particles in the diagram. Some of the species shown in the legend will not be used.

Generally

We will see from the diagram that when CCl4(l)  is placed in a previously evacuated container at 30°C , and some of the CCl4(l) evaporates that the molecules of CCl4(g)  becomes loosely held and apart from while in its closely held in its liquid state

For more information on this visit

https://brainly.com/question/17756498

Answer:

there was too much heat

Explanation:

Elements are the smallest unit of the atom and cannot be divided. An element having 5 electrons, protons, and neutrons is a boron.

Subatomic particles are the constituents of atoms that have mass and charge. They are the components that make the element unique and give the atomic number and the mass.

The electron is a negatively charged particle and protons are positive particles that along with neutral neutron give the atomic mass. An element with 5 sub atomic particles is called a boron.

Therefore, the element is boron.

Learn more about sub atomic particles here:

https://brainly.com/question/23453530

#SPJ2

Answer:

The answer is "Each student will get a glass of water and drop the bead into it  but the beads float 0.6 g / cm3 and slip down to 1.2 g / cm3

".

Explanation:

One's masses would've been dissimilar, even though their width and concentrations were also equal. Whenever the type-A mass is m,  then the type-B mass is 2 m. One should measure then, therefore.  

Water has a 1g / cm^3 density. Although Type A is higher than air, Type B is much more compact. it means will float if they place  it in water type-A where type-B sinks.

Answer: when you go outside protect your skin with sunscreen, protective clothing, a hat, and sunglasses

Explanation:

Answer:

bob up and down

Explanation:

i think it is the answer i am not sure

The mass of a pure substance represents a specific number of pure substance 'molecules', as defined by molecular weight. The relative atomic mass (atomic weight) in grams/mole (g/mol) is the molar mass of a substance, which means it is the mass of one mole of that substance.

Answer:

1 sec......................

Answer:

happy halloween Baby i love you

Explanation:

Answer:

1.493 trillion

Explanation:

Answer:

you must convert km to meters

Explanation:

If each side of the equation has the same number of atoms of a given element, that element is balanced. If all elements are balanced, the equation is balanced. So your sentence should look like this:

A chemical equation is balanced if there are equal atoms of each kind of element on both sides of the equation.

Answer:

The answer is 106.59 and 1 lb = 0.45359237 kg.

Explanation:

Answer:

stay the same

Explanation:

you would weigh less if u stood on a scale but you're still the same mass unless you chopped of a body part or something

Answer:

A ability to decompose

B reactivity

Explanation:

Chemical properties are those properties that tell us about what a substance can do as regards to whether or not the substance reacts with other substances.

Examples are flammability, rusting of iron, precipitation, decomposition of water by an electric current.

The ability to decompose and reactivity are chemical properties of a substance.

Answer:

1. A

2. B

Explanation:

Chemical property does change the composition of a substance.

I took the test before. I got all the answer correct and got 100% score.

You can see my other article just search in search engine with: Learningandassignments diy4pro

Click on my site and find these related article post:

Learning Properties of Matter Quiz Unit 2 Lesson 11 Grade 8

Hope it helps.

#diy4pro

Answer:

atoms bonding

Explanation:

Answer:

The correct option is;

Element 2

Explanation:

The ionization energy is the energy required to eject an electron from a gaseous ion or atom

The ionization energy increases across the period and increases up the group

The elements with the highest ionization energy are those that have the complete octet structure in their outermost shell, which are the noble gases

Therefore, given that element 2, which has the complete octet structure in the outermost shell, then it is an element of the noble gases which have the highest ionization energy in a period, and therefore has the highest ionization energy.

On the periodic table, the element with 10 electrons is Neon, with ionization energy of 2080.68 kJ/mol which is the second highest after helium, that has only 2 electrons.

Answer:

They have skin covered with scales.

Answer:MgO reacts with nitric acid

Answer:

In a 7-step scientific method, Spongebob utilized the 6th step when He wrote a brief summary of the investigation, and Spongebob utilized the 7th step when He also determined that his hypothesis statement was not right and explained why it wasn't right by providing evidence from the investigation.

Explanation:

Scientific Methods are organized ways employed by scientists to tackle problems by providing solutions to the problem or make hypotheses to which other scientists build on to provide solutions to the problem.

The steps of the scientific method are:

Step 1- Understand the Problem

Step 2-  Make research

Step 3- Hypothesis.

Step 4- Conduct an experiment to test the hypothesis

Step 5- Observations.

Step 6-Results/Conclusion.

Step 7- Communicate your research

When Spongebob wrote a brief summary of the investigation, which means he had already conducted an experiment and had already made necessary observations and data collection, so he was at step 6. At step 6, he had analyzed the data collected.

When Spongebob determined that his hypothesis statement was not right and explained why it wasn't right by providing evidence from the investigation, then he was at the final step of the scientific method. Step 7 tells whether the hypothesis is true or false.

Answer:

hey im spongebob

Explanation:

:D

Answer:

A limitation of models in science is that they are usually simplified versions of the real situation or concept.sometimes, models spark debates leading to new and improved models.A model may be used when it is impossible to create the conditions necessary to test a concept of theory.

hope it is helpful...

Answer:

Informercials, like the class Shamwow Informercial are an example of how structure and technique can have a huge effect on how a user or prospect is driven towards taking a specific action like clicking a buy button.

Informercials follow a specific structure that any small business can use to drive action but few businesses ever consider using it when they pitch their product or service. In this post, we'll describe the structure and give you examples of how you can use it in your business.

The question above wants to test your ability to create an infomercial using your creativity. For that reason, I can't create an infomercial for you, but I'll show you how to create one.

First, you need to know that an infomercial is an advertisement made to be played on television, usually associated with sales, but can be used to present information.

Based on this, you should create your newsletter as follows:

In the image below, you can see a tutorial on how to make an infomercial.

More information:

https://brainly.com/question/12603070?referrer=searchResults

Answer:

They would be carnivores.

Explanation: