Answer:
Frequency
Explanation:
I do not see the options but I know the answer:
The frequency of a sound wave is what your ear understands as pitch. A higher frequency sound has a higher pitch, and a lower frequency sound has a lower pitch.
If you find my answer helpful
Pls consider marking my answer as Brainliest! It would mean a lot!
Answer:
frequency
Explanation:
vaild
What is the last energy level of N? Mg?
Answer:
2
3
Explanation:
To infer the last energy of the given atoms, we need to write their electronic configuration:
For N = 1S² 2S² 2P³
Mg = 1S² 2S² 2P⁶ 3S²
The energy levels are usually designated as;
n = 1
n = 2
n = 3
n =4
For N, the last energy level is 2
Mg, the last energy level is 3
We can also determine this number by the periods the atoms can be found.
1. Collect data: Create two water cycles using the Gizmo. Each cycle should have at least four steps and should begin and end at the same location. Choose any starting point from the list on the right. When the cycle is complete, choose the PATH tab and write the steps below.
Answer:
Cycle 1: Lake,atmosphere, clouds,rain,lake
Cycle 2: Atmosphere, clouds, rain, ocean
A student observes that instant tea dissolves more rapidly in a cup of 250 mL of stirred hot water than in a cup of 250 mL of stirred cold water. Which is the most relevant hypothesis that the student could develop based on this observation?
A.
Volume affects the rate that instant tea dissolves in a solvent.
B.
Temperature affects the rate that instant tea dissolves in water.
C.
Stirring affects the rate that instant tea dissolves in water.
D.
Pressure affects the rate that instant tea dissolves in water.
Please answer my question!
Answer:
B
Explanation:
In this question, there is no mention of pressure, so we can eliminate answer D. In both cups, it mentions they contain 250 mL of water and both are stirred, so these would be constants. The only difference between the cups is temperature, so temperature must affect the rate that instant tea dissolves in water. Therefore the answer is B.
What is wrong with the answer, 10.5 x 10^3? Think about the proper form used to show a number in scientific notation.
Answer:
1.05 × 10^4.
Explanation:
The proper scientific notation will be
1.05 × 10^4.
8. Which word best describes the element in box number 2?
a а Brittle
b Gas
С Semiconductor
d. Shiny
Answer:
gas
Explanation:
i think it might be gas
cy sprints 100 meters in 13 seconds going south. what is his average velocity?
Answer:
Explanation:
This should be in physics.
d = 100 meters south
t = 13 seconds
v = d/t
v = 100 / 13
v = 7.69 m/s going south.
The point is that you have to specify the direction.
When calculating percent error, the accepted value is in the denominator
True or false
Answer:
True
Explanation:
GIVING 5 STARS AND BRAINLY IF YOU ANSWER FIRST AND CORRECTLY
Please answer asap. Thank you.
QUESTION:
How many total elements are involved in the process of photosynthesis?
A. 2
B. 3
C. 4
D. 5
Convert 122 moles of Methane to liters?
Radio waves are primarily used to
Answer:
Radio is used primarily for communications including voice, data and entertainment media.
What would happen if there were 3 protons and 0 neutrons in the nucleus of an atom?
Answer:
the atom will be positife atom
Is steam a water , oxygen or hydrogen molecule ?
Answer:
In thermolysis, water molecules split into their atomic components hydrogen and oxygen. For example, at 2200 °C about three percent of all H2O are dissociated into various combinations of hydrogen and oxygen atoms, mostly H, H2, O, O2, and OH.
Explanation:
Elements in group to are cold alkaline earth metals what is most similar about alkaline earth metals how many protons and neutrons they have which Chemical properties he have how many total electrons they have which period They have most often found in
Answer:
explanations below
Explanation:
The alkaline earth metals are the 6 chemical elements that can be found in group two of the periodic table. These elements have a lot of properties in common, in the sense that they are generally shiny, reactive at standard temperature and pressure and they are also silvery-white. The elements are beryllium (Be), magnesium (Mg), calcium (Ca), strontium (Sr), barium (Ba), and radium (Ra)
These metals have two electrons at their orbits, which can be easily lost to form cations (with charge +2, and an oxidation state of +2)
Below are some of their details
Name: Beryllium
Number of Protons/Electrons: 4
Number of Neutrons: 5
Name: Magnesium
Number of Protons/Electrons: 12
Number of Neutrons: 12
Name: Calcium
Number of Protons/Electrons: 20
Number of Neutrons: 20
Name: Strontium
Number of Protons/Electrons: 38
Number of Neutrons: 50
Name: Barium
Number of Protons/Electrons: 56
Number of Neutrons: 81
Name: Radium
Number of Protons/Electrons: 88
Number of Neutrons: 138
Which isotope of sulfur is the most naturally abundant
Answer:
The Isotope of sulfur.
32S 94.99% stable.
33S 0.75% Stable.
Explanation:
What do we call the molecule that forms when two atoms of the same element are covalently bonded to each other?
Answer:
Covalent Compounds and Diatomic Elements
Explanation: The two atoms that are held together by a covalent bond may be atoms of the same element or different elements. When atoms of different elements form covalent bonds, a new substance, called a covalent compound, results. Water is an example of a covalent compound.
1. Using a triple beam balance and a graduated cylinder, a student collected data on a sample of an
element:
Mass of sample - 67.9 g
Volume of water - 52.0 ml
Volume of water and sample - 28.0 ml
a) Calculate the density of the sample. Show all work and use significant figures and units.
Answer:
d = 2.8 g/mL
Explanation:
Given data:
Mass of sample = 67.9 g
Volume of water = 28.0 mL
Volume of water + sample = 52.0 mL
Density of sample = ?
Solution;
Density is equal to the mass of substance over volume of substance.
Formula:
d = m/v
d = density
m = mass
v= volume
Now we will calculate the volume of sample.
Volume of sample = (volume of water+ sample) - volume of water
Volume of sample = 52.0 mL - 28.0 mL
Volume of sample = 24.0 mL
Now we will calculate the density.
d =67.9 g /24.0 mL
d = 2.8 g/mL
Where exactly is an orbital? I understand they are a volume where we expect to find electrons 90% of the time but I don't understand where their shapes are and fit on an atom, and the different forms of orbitals confuse me a little. Can someone explain me where they are with the help of an image? Pardon me if my question isn't very clear
Answer:
95% of the time (or any other percentage you choose), the electron will be found within a fairly easily defined region of space quite close to the nucleus. Such a region of space is called an orbital. You can think of an orbital as being the region of space in which the electron lives
what do you mean by international understanding peace
and cooperation
Answer:
International understanding or internationalism is a feeling that the individual is a not only a member of his country, but a member of the world as well. To ensure world peace. To prevent world wars. To promote human welfare. To promote mutual understanding and interdependence.
How many neutrons make up one of these potassium atoms?
Answer:
20
Explanation:
What is the volume of kristas rock
Answer:
30
Explanation:
Measure the water rised in the beaker which is 180 and subtract 150 and you get 30
The density of a pure liquid at 25 degrees Celsius was calculated by determining the mass and volume of a sample of the liquid. A student measured the mass of a clean, dry 25.00 mL volumetric flask, filled the flask to its calibration mark with the liquid, and then measured the mass of the flask and liquid. The recorded measurements are shown in the table above. On the basis of this information, to how many significant figures should the density of the liquid be reported?
Answer
The density of the liquid is 0.82 g/mL.
Explanation:
From the question given above, the following data were obtained:
Mass of empty flask = 18.990 g
Mass of flask + liquid = 39.439 g
Volume of liquid = 25 mL
Density of liquid =..?
Next, we shall determine the mass of the liquid. This can be obtained as follow:
Mass of empty flask = 18.990 g
Mass of flask + liquid = 39.439 g
Mass of liquid =.?
Mass of liquid = (Mass of flask + liquid) – (Mass of empty flask)
Mass of liquid = 39.439 – 18.990
Mass of liquid = 20.503 g
Finally, we shall determine the density of the liquid as follow:
Mass of liquid = 20.503 g
Volume of liquid = 25 mL
Density of liquid =..?
Density = mass / volume
Density of liquid = 20.503 / 25
Density of liquid = 0.82 g/mL
Which further observation led Mendeleev to create the periodic table
Answer:
Mendeleev realized that the physical and chemical properties of elements were related to their atomic mass in a 'periodic' way, and arranged them so that groups of elements with similar properties fell into vertical columns in his table.
Explanation:
Dilute hydrochloric acid reacts with sodium
2HCl(aq) + Na2CO3(aq) + 2NaCl(aq) + H2O(l) + CO2(g)
A Explain why effervescence is seen during the reaction.
Answer:
Because the reaction releases CO2 gas
Explanation:
therefore creating an effervecence within the solution as the carbonate dissociates
What happens to an egg that is not fertilized?
OIt is reabsorbed by the body
O It travels back up the fallopian tube.
OIt exits during childbirth.
O It is released during menstruation
Answer:
D. It is released during menstruation
Explanation:
The egg that is not fertilized is released during the process of menstruation.
What is menstruation?
Menstruation (also known as a period, among other colloquial terms) is the regular discharge of blood and mucosal tissue from the inner lining of the uterus through the vagina. The menstrual cycle is characterized by the rise and fall of hormones. Menstruation is triggered by falling progesterone levels and is a sign that pregnancy has not occurred.
The first period, a point in time known as menarche, usually begins between the ages of 12 and 15.Menstruation starting as young as 8 years would still be considered normal.The average age of the first period is generally later in the developing world, and earlier in the developed world. The typical length of time between the first day of one period and the first day of the next is 21 to 45 days in young women. In adults, the range is between 21 and 31 days with the average being 28 days.
Learn more about menstruation,here:
https://brainly.com/question/9864045
#SPJ7
Which helps in the production of eggs?
Answer:
Feed Consistency.
Explanation:
Feeding that is supposed to yield the volume of a gnome for our chickens to lay eggs.
The Boxes of Clean Nests.
The Areas Free.
With calcium.
Regularly check it.
Protection Coop.
About fresh water.
Controlling Parasites.
Answer:
A. testosterone
Explanation:
i took the unit test
Which description applies to a physical property? Choose the correct answer
O depends directly on the amount of the substance present
O examines changes in the composition and structure of matter
O measured or observed without changing the identity and composition of matter
O determined by changing the identity of a substance and observing how it reacts
Answer:
the third one, measured or observed without changing the identity and composition of matter. because physical property does not under go any change but can be put back.
One way to separate the different kinds of matter in a mixture is through
A. filteration
B. decomposition
C. electrolysis
D. chemical reactions
One way to separate the different kinds of matter in a mixture is through filtration. The correct option is A.
What is filtration?Filtration is a physical or mechanical process by which two or more substances are of different compositions. These substances can be solid, liquid, or gas.
There are three types of filtration. These are mechanical, chemical, and biological. The different types of filtration are based on a similar principle, which is a mixture of several types poured onto a filter membrane. A specific size of the pore is present in the filter membrane.
The other options are decomposition, which is a process of breaking down substances. Electrolysis is separating charged ions and chemical reactions to form compounds.
Thus, the correct option is A. filtration.
To learn more about filtration, refer to the link:
https://brainly.com/question/14530470
#SPJ6
You will learn in this course that organic compounds have covalent bonds with a significant amount of energy stored in them. This is why we burn fossil fuels to generate energy to heat our homes or drive our cars. Given this information, which of the compounds listed below would you expect to have the most energy is its carbon-carbon bond?
Answer:
See explanation
Explanation:
This question is obviously supposed to be a multiple choice question but the options are missing.
However, the question intends to test the student's knowledge about combustion of fossil fuels. Fossil fuels are mostly composed of hydrocarbons of different chain lengths.
The longer the chain length, the greater the energy released when the compound is burnt since there are more energy stored in its bonds.
Hence, the correct answer to this question will be the option that contains the greatest number of C-C and C-H bonds.
Please answer it correctly and explain clearly
Answer:
i think that the children will inherit the brown eyes, it is the best answer since the other things cant be inherited and he dyed his hair blonde
Explanation:
What questions might remain that will one day be answered by new technology?
Answer:
Can we find a safe cure for cancer?
Explanation:
pls mark brainliest